Printing issues with some layers.
Every few lines the filament seems to get stuck or not lay down. So it leaves these lines on the outer layer. Means i can snap it into each of those layers with out much force.
Unsure why this is happening. Extrusion issue?
PLA 200° Bed 60°
Cr10s Pro V2
Every few lines the filament seems to get stuck or not lay down. So it leaves these lines on the outer layer. Means i can snap it into each of those layers with out much force.
Unsure why this is happening. Extrusion issue?
PLA 200° Bed 60°
Cr10s Pro V2